V2000-c Rfid Access Control User Manual

The V2000-C uses a relay to control the door lock. Understanding the jumper settings is essential for configuring your specific lock type (fail-safe or fail-secure). The controller is typically connected to an EM lock, an exit button, and a 12V DC power supply.

In today's fast-paced world, security and access control have become a top priority for individuals and organizations alike. One of the most effective ways to ensure secure access to a premises or a specific area is by using RFID (Radio Frequency Identification) access control systems. The V2000-C RFID access control system is a popular and widely used solution that offers a high level of security, flexibility, and ease of use.

Dedicated dry contacts for an external doorbell button Wiring Configurations

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. V2000-c Rfid Access Control User Manual

The connector is a dry contact relay for the lock. You can set its normal state using the J1 jumper.

The is designed for durability and simplicity . Unlike biometric fingerprint scanners, the RFID + PIN keypad is reliable in dirty, wet, or outdoor environments where fingerprints might fail. It is ideal for construction sites, warehouse gates, and back-entrance doors.

Enter Programming Mode →right arrow Press 4 →right arrow The V2000-C uses a relay to control the door lock

I can provide the exact wiring loop or programming steps for your setup. Share public link

999999 (or sometimes 888888 depending on production batch).

To manage system users or security settings, administrators must enter . All setup commands must begin from within this environment. Step 1: Entering Programming Mode In today's fast-paced world, security and access control

Add Card Users by User ID Slot (Recommended for inventory management) Enter Programming Mode. Press 1 + User ID (1 to 4 digits) + # + Swipe Card + # . Add PIN Users Enter Programming Mode. Press 1 + User ID (1 to 4 digits) + # + PIN (4 digits) + # . Deleting Users Delete User by Card Swipe Enter Programming Mode. Press 2 + Swipe Card + # . Delete User by User ID Slot Enter Programming Mode. Press 2 + User ID (1 to 4 digits) + # . Delete All Users (Factory Wipe) Enter Programming Mode. Press 2 + 0000 + # .

The master code is now restored to factory default ( 9999 ), but your saved user cards and PINs will remain intact. Card Read Fails (No Sound, No Light Change)