The meter screen may remain blank or show a data transfer message.
Match your exact firmware download to these numbers. Flashing software meant for a different hardware revision will corrupt the bootloader. Step 2: Setting Up the PC Connection
: If the meter blanks out, you used the wrong hardware revision file. Re-flash the device using an older, verified stock firmware file. Post-Upgrade Optimization
Plug the 3.5mm jack into the serial port of your Satlink meter.
Click the or Next button on the PC software interface. The program will display a status waiting for the device connection. Switch the power button of your Satlink WS-6906 to ON . satlink ws-6906 software upgrade
: Updates can increase the device's accuracy and sensitivity when locking onto specific satellites.
Pro Tip: For some models, hold the button while powering on to force entry into update mode.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Once the update was settled, the differences were immediately noticeable. The meter screen may remain blank or show
The correct .bin or .abs software file matching your specific hardware revision. Step-by-Step Software Upgrade Process
Right-click the port, select > Port Settings , and ensure the Bits per second (Baud Rate) is set to 115200 . Step 3: Running the Upgrade Software
: Check your serial cable seating. Ensure you turn on the meter after clicking start. Verify you selected the correct COM port.
Follow these steps precisely to ensure a successful software flash. Step 1: Install Drivers and Identify the COM Port Plug your USB-to-RS232 adapter into your PC. Install the necessary drivers for the adapter. Open on your Windows computer. Expand the Ports (COM & LPT) section. Step 2: Setting Up the PC Connection :
: Place the firmware file in the root directory of the drive.
A valid, uncorrupted firmware file ending in a .bin extension, specific to the WS-6906 model. Step-by-Step Software Upgrade Procedure
Follow these steps precisely to avoid bricking your satellite meter. 1. Prepare the Connection Ensure the Satlink WS-6906 is powered completely off. Plug the 3.5mm jack into the meter's serial port. Connect the RS232 end to your PC (or USB adapter). 2. Identify the COM Port Open on your Windows PC. Expand the Ports (COM & LPT) section.